-
I ordered 10 esp32-cam modules of this brand. (as shown in the first image on [the wiki page](https://github.com/donny681/ESP32_CAMERA_QR/wiki))
Unfortunately, none of them are working using a sta…
-
The Arduino freezes once in awhile it only seems to be happening with my hard driving so right now I think it's trying to open the menu because there is no speed check for that but that doesn't always…
-
I used the precompiled MicroPython binaries v1.12 for my TTGO T-Display since June 2020 and it works very well. Recently I downloaded the binaries v1.17 and v1.18 and the same code no longer works. Fl…
-
Freely discuss your opinions on an ARM platform for Grbl, moving forward after v1.1.
-
ESP32S3, 使用GC2145,输出RGB565格式的图像, 当分辨率小于等于FRAMESIZE_XGA时, 能够正常输出, 当分辨率大于FRAMESIZE_XGA时, 输出错误信息: cam_hal: EV-EOF-OVF.
//EXPERIMENTAL: Set to 16MHz on ESP32-S2 or ESP32-S3 to enable EDMA mode…
-
Every time Camera reboots, the displayed name in PrusaConnect resets to ESP32-CAM.
I manually edit it and it's fine until the camera reboots
-
I have to wifi cards installed (which has monitor mode)
```
pi@PiNas:~ $ iw phy1 info
Wiphy phy1
max # scan SSIDs: 4
max scan IEs length: 2257 bytes
max # sched scan SS…
-
### The Problem
After updating to 15.0.3 from 15.0.1 somehow the prevalue.ini got corrupted (0 bytes, possibly FAT corruption also. Not sure).
I don't blame 15.0.3 for this. It was probably just bad…
-
### Board
ESP32 DEV modules with cameras
### Device Description
AI-THINKER ESP32-CAM
- but will also affect any board using the esp-cam code/examples
### Hardware Configuration
ftdi serial for p…
-
### Hardware:
Board: ESP-WROOM-32(self-assembled board with manual reset)
Core Installation/update date: NA
IDE name: Arduino IDE 1.8.1
Flash Frequency: 40Mhz
Upload Speed: …