-
Update to RC6, everything uploaded fine, it just won't connect. Tried Repetier Host and Octoprint.
Appears to be a Marlin-specific issue, if I install Repetier Firmware, I am able to connect without…
ghost updated
2 years ago
-
Okay, sorry, not a bug per se, seems to be completely related to cold hardware not being ready for fast CV action for about 20 minutes. After that no glitchy behaviour anymore. Will monitor this furth…
-
Hello. After G29 command not working raise between probing points. I don't understand why or what wrong I do?
Marlin 1.1.0-RC7
This is my configuration.h:
``` cpp
#include
/**
* Marlin 3D Pr…
-
We found the following vc4_dsi commit (partially) breaks our panel driver:
https://github.com/raspberrypi/linux/commit/a2b8b34d78d9721196b0010b00d0db5f4392aa5b
We have parent_rate: `3000000091`,…
-
Hi,
I tested this version and while trying to find the best auto level routine. The g30 and g29 work reliably and as expected. When I visualize the result of g29 I get a repeatable pattern.
I print…
-
Any bump in my nozzle based z-min probe that closes the switch causes the layers of my prints to shift. Manually triggering the switch reliably reproduces the issue. Confirmed that this is an issue on…
-
There appears to be an issue in the 4.3 Release Candidates for the boards utilizing the MATEKF411 target and GHST Protocol. GHST doesn't work with RC6 or RC5, but it does work with RC4. Didn't conti…
-
### The problem
Hey ZHA Crew,
Been awhile but Thanks for implementing the Volt, Amperage, Total Power values in the smart socket.
Living in the Netherlands we use the , (comma) as the decimal s…
-
I have ben having some trouble using my 2 flickerfixers / scandoublers on the board.
A little backstory.
I have 2 scandoublers / flickerfixers which both works out well on my stock A2000 rev6
I h…
-
**nanoFramework area:** (PWM Library)
### Is your feature request related to a problem? Please describe.
### Describe the solution you'd like
Hi, I'm looking at controlling a half-bridge for D…