-
Let's try to make some order.
Please:
1) How I can make sure that the LaunchXL have debug problem solved?
Personally I think is solved, because now I don't have any errors message, I just in dou…
-
Hi there! I am having a hard time connecting the Tango v1 board to my Anet A8 with BLTouch sensor and Anet 12864 Full Graphics LCD. Apparently the connections EXP1 & EXP2 don't match the ones on the L…
-
Hi
Thanks for the code. I loved the design of the clock but the wifi and NTP really brought it together.
I've built the clock and everything is working, however initially I was struggling to get…
-
Nice design, Can you upload your BOM here?
-
Hi there,
I am using the TMC5160 with a custom setup for driving actuators, I used them quite for a while with different setups and length and everything always worked out well. For a new project i a…
-
Hi all!I had posted before and managed to make the els work out. After some time now the motor only turns on one direction...the screen was flickering before and now i move the lathe chuck on any dire…
-
### Is your feature request related to a problem? Please describe.
I want to connect MKS SERVO42C NEMA17 Closed Loop Stepper Motor Driver to an SKR 3 board. Is the "MKS SERVO42C NEMA17 Closed Loop St…
-
Uart cable connector for RX & TX should be separate from 5V, 5V & GND.
Orange Pi Zero 2W has reserved GPIO pin 8 & 10 for UART0 for debugging & console.
If RX & TX cable were separate, then UAR…
-
Only a question: is it possible to connect the ESP8266 board to the ortur master 2 control board?
If yes, is there a connection diagram?
-
## Blogs
- https://github.com/Staok/thoughs-about-hardware-design
- https://www.emoe.xyz/all-about-electronics/
- https://www.analog.com/cn/resources/reference-designs.html
- https://www.envox.eu/…