-
@embest-tech said:
> We found the board goes to uboot mode when the board start without serial cables, the reason is that U46 2# pin input is floating , even if we had a pull-up resistor(R173) in t…
-
### Description
Tft display stop responding after touch object spi begins, touch works perfectly but stops tft.
### Steps To Reproduce Problem
Please give detailed instructions needed for anyone …
-
```
It just a question.
Motor 1 channel have some voltage, even all PID & PWN% are 0.
I tried so many firmware version, also the same.
motor 2 channel is fine and I can configure correctly.
But I ha…
-
Hello
I have the following board with 3.5” tft display using a ILI9488 driver:
https://www.elecrow.com/esp-terminal-3-5-inch-320-480-spi-tft-capacitive-touch-display-with-ov2640-camera.html
Jus…
-
When?
-
**Issue by [ymkc](https://github.com/ymkc)**
_Monday Feb 01, 2016 at 16:27 GMT_
_Originally opened as DarkstarProject/darkstar - Issue 2714_
----
Once the airship reaches it's destination, the scre…
-
```
It just a question.
Motor 1 channel have some voltage, even all PID & PWN% are 0.
I tried so many firmware version, also the same.
motor 2 channel is fine and I can configure correctly.
But I ha…
-
```
It just a question.
Motor 1 channel have some voltage, even all PID & PWN% are 0.
I tried so many firmware version, also the same.
motor 2 channel is fine and I can configure correctly.
But I ha…
-
```
It just a question.
Motor 1 channel have some voltage, even all PID & PWN% are 0.
I tried so many firmware version, also the same.
motor 2 channel is fine and I can configure correctly.
But I ha…
-
```
It just a question.
Motor 1 channel have some voltage, even all PID & PWN% are 0.
I tried so many firmware version, also the same.
motor 2 channel is fine and I can configure correctly.
But I ha…