-
it just sits there after in the back right corner and just dumps filament out after it is heated up, doesn't move where it is suppose to print. Slow down the video and it is at the very end
[petgMSV_…
-
Introduce new version
full documentation https://github.com/akaJes/marlin-config#readme
installation: `sudo npm -g i marlin-conf`
then right click in Marlin folder with git repository and choose…
-
I calibrated my delta printer which has a probe that is activated by pressing down the nozzle and when I send a G1 Z0 command the effector goes down just to spot where the nozzle presses into the bed …
-
### Description
I have a printer that uses the X-Y-Z-E axis from a stock Creality Ender 3. I'm running Marlin 1.x on a MKS GenL . My Z-Axis falls under its own weight under normal circumstances. I'…
-
I'm trying to find out how to send " ˶ " character to activate safety door operation.
If for example i was to write a tool change function into my post processor which when it received the tool iden…
-
Version 1.1.9
### Description
Sending this Sequence of commands:
- T0
- G28 X
- T1
Causes the X axis to crash on the tool change. This seems identical to the old issue
#3823. There i…
sdtom updated
4 years ago
-
We have a problem with the pulse input to the motor for E axis(the extrusion) on our mixng extruder.
The E motor will run with the XYZ motor even if we didn't give the G-code for E axis after we set…
-
Hi. I have problém with heating bed
If i set some temp heating stop 10 degree leds for example set 60*c hotbed stop heating 50 *c
But If i try calibrate PID heating is ok
Please help
Marlin fi…
-
I upgraded from 2.0.1.56 to 2.0.1.59 before committing to purchase your CNC tool. The earlier version worked great. Now the viewer does not work. I found the earlier issue where you suggested settin…
-
Last night I finally had everything working and calibrated. I tried to test print a dice it was working well and froze 20 minutes later.
I tried to cancel the job. Manual jog didn’t work, reset or…
azant updated
4 years ago