-
To prevent dangerously high LC spikes, Pololu recommends placing a 100uF capacitor across the rails of each driver, as [outlined here](http://www.pololu.com/docs/0J16/5).
Currently, a single 100uF ca…
-
integrate Microchip UPD1002 and USB type connector for power supply.
-
Hi,
We have a few units (RPi4) configured to use Pi Juice Zero boards to assist with start up and clean shutdown via button press and power cut
Power is supplied to the Pi Juice via the 4.2-10v …
-
I recently acquired two T-Halow modules and configured IP addresses through the Ethernet bridge. However, when I disconnect the Ethernet cable, they lose connectivity. This is expected, but can we co…
-
Only seems to happen when the watch has been left alone for a while.
OLED display appears to briefly power-up before resetting the MCU.
Reset flags usually report a brown-out.
My best guess at the mo…
-
With the newest version of OpenModelica, we see strange spikes in the figure titled "Flat power supply circuit"
-
I notice there is no FAQ. This would help with lots of questions, such as what is the model of power supply? where is the sim? etc.
Might I offer a first item?
Q: What power supply is used?
A: …
-
I'm getting prominent diagonal lines in my image. This happens with every console I try. I also used several different power supplies. I'm currently using this one: [Triad Magnetics WSU050-3000](https…
-
When quickly switching (1-2 sec) cameras, only from different groups, using companion, the RP150 randomly reboots.
We have 4 RP150 remote controls and they all reboot.
We tried changing the firmwa…
-
Bug Description
I'm developing a Unity project using Azure-Kinect
The product is connected normally, but the power supply is disconnected, and if Azure-Kinect is run after re-energizing, it is not…