-
The thingspeak controller as it is today does not obey the 15 seoncs rule that says that you must send only one message every 15 seconds. If you send in shorter intervals, the message will be ignored…
-
Hi,
I am using the IAQ_I2C Arduino Sketch which works well.
I am trying to extend this sketch so that I can send the IAQ values to Thingspeak after the measurement, however, right now the sketch…
-
I was wondering if I should design an oximeter to mount the pulse sensor and also to allow for people to exert a constant "goldilock" pressure so that the readings will be accurate.
Since the docum…
-
Hi There,
I'm using the Browan Object Locator function to ingest data into Azure IoT Hub. It's working nicely but sometimes the temperature reading goes a bit strange. Here are some examples from tod…
-
https://www.adafruit.com/product/1120
#7
-
I am using a RPi and MPU-9250 set for address 0x69. I can read and calibrate all of the sensors except the Y and Z gyro which appear "stuck" no matter how many different ways the board is tilted. The …
sfeek updated
4 years ago
-
Hi. Is it possible to do some SPI operations in a defined timeslot without disturbing the mesh radio? I would like to read a sensor every 0.001 sec and send the average readings every 5 sec over the m…
-
Reading the code, I assume that a fixed value is used for pressure as an approximation. It might be nice to be able to pass in a pressure value from an atmospheric pressure sensor to make these values…
-
HI,
Your project is very good and i've try to add minor features to him - to regulate the output sine voltage and migrate to H-Bridge .
Modified those lines :
if (ctr > TRANSISTOR_SWITCH_STEP)
…
-
Hi,
I was successfully using HomeBridge with both yeelight and aqara plugins. I had no issues at all until today, when I've decided to change the location of my Xiaomi Temperature and Humidity Sens…