-
I see the LispBM has access to almost all variables while the UART don't. I need to set motor currents in real time and so I had to add the l_current_min and l_current_max UART commands, just duplicat…
-
My goal is to have a self-contained device that is powered by either the RJ45 port's 9V pin or by a microUSB connector and can communicate with a computer over usb or WiFi.
I'm currently using a de…
-
Without any optimizing (and using i64_t way more than is probably necessary, and Arduino that's really slow), the time inside the TICC measurement loop from "got data" to end of calculation is around …
-
I think we should define coding convention, and create some test cases.
-
Hi everyone,
Today i problem with board BIGTREETECH-SKR-V1.3
i change or replace new TMC2208 but not work.
The error “tmc connection error”
This is video error
https://www.youtube.com/wa…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
YyeHG updated
9 months ago
-
hi i have 2109:2822 VIA Labs, Inc zigbee stick and need to enable cdc for it. does this driver supports it ?
-
When the internal USB of esp32-s2, esp32-s3 and esp32-c3 is used to output the REPL information, the internal REPL function cannot work normally.
At present, most micropython firmware of esp32-s2, …
-
OLA olad version: 0.10.3
I've followed the guide for setting up the Enttec Open DMX USB. It works fine, and the daemon reloads itself when plugging in the USB cable. However, when unplugging withou…
-
I'm not 100% sure this is the right location to file the issue; but I'll start here.
I have a Creality Ender 3 Pro 1.1.4 board; which a few guides refer to as a Sanguino / ATMega1284p.
I followe…