-
I just updated my 9FUSY31GA2N6SB200319 camera with YI 8.2.0.0A_202007211802 firmware from 0.2.2 to 0.2.4 using the `Online FW upgrade `web interface.
The `rRTSPServer` is now failing (i.e., if no l…
-
I followed instructions of install of this component.
When I trying to fill a form with Yi Camera data (address, port, login, password) I received an:
"User input malformed"
-
For instance, in the supported list of camera: None of those match with this list
YI "Small Ant", Mijia 1080P, Xiaofang, ChuangMi, Mijia PTZ (720P), Mijia AI PTZ (1080P), Dafang PTZ
or this li…
-
Hello,
Using Allwinner with Yi cam
Yi 1080p Home 9FUS
Firmware : 8.3.0*
File : y25ga
The mqtt messages received from the camera looks a little crasy.
There are more "human_stop" than "human_…
-
I am testing your commits and wondering if the code is now covering requirements for more topics to be advertised
```
Logger: homeassistant.config_entries
Source: custom_components/yi_hack/__init…
-
Hello.
I just installed 0.3.1 on my 0.2.8 y291ga camera, and as I update the onvif settings in Synology Surveillance Station and re-login, the correct credentials are rejected by the camera and I c…
-
I'm trying to find a way to make 'cut off' mp4 files playable. These are files that were copied from the camera while the Yi software was still writing to them. So far without much luck unfortunately.…
-
Camera: Yi 1080p Home (YYS.2016, RFUS, 9.0.35*, y291ga)
Camera has been working fine for months along with several others. Today, after a power cycle, this camera came back online, but the web inte…
-
Hi, I recently bought a Reolink camera that has functions to detect people, vehicles and animals. After adding it in synology surveillance station using ONVIR, I have the ability to mark when NVR shou…
-
Hey!
I have two YI home 3 9FUS camera. I successfully flashed and using the 4.3.0 release on both. The recordings go to a SanDisk 128 Gb SD card. Everything goes fine (even when the card is full) unt…