-
-
It would be useful if a firmata host could enumerate attached i2c devices on a firmata client.
A full scanner is not required, just the ability to detect the error from a wire.endtransmission .
cf i…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
```
What steps will reproduce the problem?
1. Use latest tvout library
2. 470 ohm and 1k ohm resistor
3. Plug into tv
What is the expected output? What do you see instead?
There should be an image o…
-
### Hardware:
Board: ESP32-DevKitM-1 (ESP32-U4WDH)
Core Installation version: 2.0.0-alpha1
IDE name: Arduino IDE
Flash Frequency: 40Mhz
PSRAM enabled: …
-
After getting this going on a Teensy 4.1 I noticed a pretty large amount of lag with the hal pin value changes in LinuxCNC. It's very obvious when spinning an MPG wheel fairly fast, it takes the hal p…