-
```
What steps will reproduce the problem?
1. Give yourself a weapon_physgun
2. Grab any ragdoll
3. Observe the beam end point position in comparison to your target
What is the expected output? What …
-
```
What steps will reproduce the problem?
1. Give yourself a weapon_physgun
2. Grab any ragdoll
3. Observe the beam end point position in comparison to your target
What is the expected output? What …
-
Steps to reproduce
1) open sim
2) open prisms
3) drag a few prisms into the light boundaries; try to transmit as much light as possible through the prisms
4) turn on normal and reflected
5) turn on w…
-
```
What steps will reproduce the problem?
1. Give yourself a weapon_physgun
2. Grab any ragdoll
3. Observe the beam end point position in comparison to your target
What is the expected output? What …
-
@arouinfar will create a mockup
-
```
What steps will reproduce the problem?
1. Give yourself a weapon_physgun
2. Grab any ragdoll
3. Observe the beam end point position in comparison to your target
What is the expected output? What …
-
```
FDS SVN 9175
SMV SVN 9078 (Sept 16, 2011)
Run the verification called called beam_detector.fds in Verification/Detectors. Open
Smokeview and load the 3D smoke. In the past, you could only see abo…
-
Hi, Thomas
When I match a sequence with small step, i.e. 1e-6, an error occurs.
python script:HITFIL.py
``` python
# -*- coding: utf-8 -*-
"""
Created on Wed Jun 24 16:10:50 2015
@author: Administr…
-
Gijs wrote in the forum:
> The red and green lights should be visible when flying head on towards the aircraft. The table from FAR §23.1391 says that between 0° to 10°, the minimum (!) intensity shou…
-
Dear Hendrik,
Please find hereafter my comments
- Additionnal information about DAQ architecture, I propose to rewrite the paragraphe starting on page 6 line 16 + references on EUDET memo, NI talk a…