-
Hi folks,
I've followed the tutorial in the README file and I've got data flowing in to my TTN app, however the values are all over the place:
```json
{
"altitude": 60435,
"hdop": 2.04,
…
-
There is one enhancement I would like to be able to add temp/humid/pressure to the sensor.
For example to monitor if the case is broken or see if the amount of people measured depends on the envirome…
-
### Expected behavior
Local documentation build works fine
### Actual behavior
In every module documentation page, menu links to other sections are broken.
After testing various ways to build …
-
every time I attempt to run my bsec_bme680 file, terminal closes instantly without any messages. I edited make.config so that the ARCH reflects the raspberry pi 3 instead of the zero since I'm using a…
-
Adafruit_BME680: v1.0.5
Arduino IDE: 1.8.5
Arduino Uno Board
I get the following warning:
.../Arduino/libraries/Adafruit_BME680_Library/bme680.c: In function 'calc_pressure':
.../Ardu…
-
Hello Thomas,
i pretend to use more than one sensor in fhem.
How is the sensor-id configurable (eeprom during serial setup) and is LaCrosse-Gateway capable of receiving these instances?
regards,
…
-
### Hardware:
Board: ESP32 dev module, home brew PCB
Core Installation version: tested 1.0.1 and 1.0.2 rc1. < 1.0.0 works
IDE name: Arduino IDE and PlatformIO
Flash Frequency: 40M…
pwntr updated
5 years ago
-
Hi, unfortunatly hardware SPI is not working with BME680 on SAMD21 Xplained Pro board. Wiith BME280 it works on all 3 SPI interfaces perfectly.
`
#include
#include
#include
#define BME_SC…
-
Hi Kris,
where did you find the compensation algorithms for temperature, pressure and humidity. In the BME680 datasheet there is only described the compensation algorithm for gas. The algorithms de…
-
Only the Reset Switch shows up in Home-Kit, the server and the sensor are working fine, when I start Homebridge I get this Error-Message:
{ Error: getaddrinfo -3008
at errnoException (/usr/local…