-
## Do not report new issues related to this message, instead please comment on this issue with the logs that you see and the config for that component.
### The problem
```
[00:00:00][W][compone…
-
For cascaded heat pumps systems, would be great to see "Compressor WP1", "Compressor WP2" and so on separately.
Now they're all combined in a single entity called Compressor.
Is it possible to open …
-
Hello, Thank you for your great work on this code.
I am connecting a 7" TFT SainSmart with a SSD1963 controller to a Teensy 4.1. The display was originally connected to a Arduino DUE with the DUE…
-
Thank you for all of the great help you have provided in putting together the various packages. I have installed setup helper and GUI mods with no issues. When I went to install VeCan I ran into som…
-
### Describe the bug
There's currently an issue with F150 Lightnings on the Ford Q4 Harness/CAN-FD platform. This is specific to the Lightning as the ICE variants do not have this issue nor do the Mu…
-
Hello,
Is the J1939 CanBus protocol supported??
I would like reading NMEA2000 bus. Is Possible??
-
Found good test's to preform on the CAN SN65HVD230 transceivers. You can check for functionality by probing between ground and pin 5 which should be Vref(VCC/2) or around 1.65v when the module is supp…
-
-
Inputs processed in Lua (like AC request or Launch trigger) should be useable in TunerStudio, and Outputs (like AC Output) should too.
Use case example: on a car with fully CANBUS A/C, input is rec…
-
I did the filtering by specifying a range to filter out specific CAN ID.
As a result, it was impossible to obtain by filtering CAN messages within the desired range.
python-can doesn't seem to do …