-
```
What steps will reproduce the problem?
1. Connect the EV3 brick by USB
2. Run the command: gyrorate = b.inputReadSI(0,Device.Port2,Device.GyroRate);
3. The value is NaN. Doesn't matter if the robo…
-
```
What steps will reproduce the problem?
1. Connect the EV3 brick by USB
2. Run the command: gyrorate = b.inputReadSI(0,Device.Port2,Device.GyroRate);
3. The value is NaN. Doesn't matter if the robo…
-
```
This is tested with APM2.5 and arduplane 2.40, 2.60, 2.61 2.62. 2.63.
If APM 2.5 is connected to USB, it boots, you see the red/blue leds flash
during gyro calibration - thinks are "normal".
Wh…
-
```
This is tested with APM2.5 and arduplane 2.40, 2.60, 2.61 2.62. 2.63.
If APM 2.5 is connected to USB, it boots, you see the red/blue leds flash
during gyro calibration - thinks are "normal".
Wh…
-
```
This is tested with APM2.5 and arduplane 2.40, 2.60, 2.61 2.62. 2.63.
If APM 2.5 is connected to USB, it boots, you see the red/blue leds flash
during gyro calibration - thinks are "normal".
Wh…
-
```
What steps will reproduce the problem?
1. Connect the EV3 brick by USB
2. Run the command: gyrorate = b.inputReadSI(0,Device.Port2,Device.GyroRate);
3. The value is NaN. Doesn't matter if the robo…
-
I'm attempting to use Gyro with 8bitdo Pro 2 as a pointer.
When it works, it works perfectly but during a game after some time or when the (cut)scene changes the pointer goes off screen and the po…
-
```
Dear sir,
What steps will reproduce the problem?
I recently used your MARG to test my sensor bought in Phidgets.(1056)
The drift in gyro is quite serious, even if I let the sensor stays still at t…
-
I thought that the gyro readings were supposed to be in degrees, but on my iPhone SE (in Thunkable Live or built and loaded), but for the alpha angle, spinning the phone flat on the table by 90 degree…
-
```
constexpr float SIG_W_A = 0.05f;
// Std dev of gyro output noise (rad/s)
constexpr float SIG_W_G = 0.00175f;
// Std dev of Accelerometer Markov Bias
constexpr float SIG_A_D = 0.01f;
// Corre…