-
Hi,
I've been away from tinkering for a while and want to get this working on some newer boards. Ive been battling through build errors and missing libraries and found myself stuck at:
In file i…
-
Many users are uploading the wrong build for their hardware. File names for all hardware begin with openevse which is misleading. The following names are suggested to match the manufacture of hardware…
-
Can this Platformio be updated to use your v1.6 Arduino framework - should it not be set to use the latest release?
Cheers
Jez
jezdd updated
10 months ago
-
### Describe the problem
I think I Installed it the correkt way. It shows the Battery BMS (JKBMS) with all information but it does not start to charge or discharge. The Battery SoC is up to 60%.
!…
-
Hi,
I'd really like to see this working, but don't (yet) have the ESP32 devices you specify, only TTGO T3_V1.6, so i try anyway.
But bootloop. What am I doing wrong? Maybe just wait for ESP32 Lolin …
-
### Category
Other
### Hardware
Heltec V3
### Firmware Version
2.2.3.282cc0b
### Description
This is very strange story, I don't have full info and can't reproduce it right now. I don't know if…
-
### Describe the problem
As I understand it, the following parameters in config.ini determine when to switch to Float:
MAX_CELL_VOLTAGE = 3.450
FLOAT_CELL_VOLTAGE = 3.350
CVCM_ENABLE = False (…
-
### Describe the bug
I use the nightly build DEV branch with both JK BMS'ses on bluetooth. So far they connect good and all the values are displayed.
Exccept for the MOSFET Temp of one of the newer …
-
Hello. I'm trying to use the sketch "WIFI_LoRa_32_V3_FactoryTest" on two V3 devices, and they are not communicating with each other.
The Arduino compiles the code and uploads it to the board without …
-
After compiling and uploading the firmware to the Heltec WiFi LoRa 32 V2 device, the following message is displayed:
> ------- ERROR -------
> stationMode Not Valid change it on : /data/igate_conf…