-
## Current Behavior
I have a flying wing aircraft setup with a traditional elevon mix. When saving and rebooting in the configurator, if the servos are powered, they get promptly commanded beyond the…
-
INAV v4.0 release, servos freeze in MAX positions when entering the OSD menu. this can cause un-needed stress on servos attached to the rudder and pitch channels by driving them (potentially) over the…
wx4cb updated
8 months ago
-
## Current Behavior
Last week I decided to test the max speed of my multicopter while cruising in POSHOLD (ATTI) trying different max_angle settings. When I tested over 35º of angle max I w…
-
## Current Behavior
Due to some mechanical limits I had to limit my servos in the output tab to 75% way. Everything works fine except entering the OSD menu via stick command. (I never used the other …
-
## Current Behavior
not in inav
## Desired Behavior
Add custom element driven by programming tab
## Suggested Solution
I created proof of concept of custom OSD elements. Element is divided to…
-
## Current Behavior
My wing (540mm wingspan) roll rate was really fast at 350 degrees per second, even though the roll mixer setting was just at 25%. But the servo speed wasn't keeping up, which ma…
-
Flashed Flywoo F405 Pro on F405 versatile board as it is only target available.
ESC is flashed with blueJay same was working on Inav -6 but on inav7 esc are not detected same is not detected on ESC c…
-
Hello,
i have just bought an Upixels Optical flow sensor and used it with ardupilot, now i wonder if it is possible to use it with inav, it hjas the UPIXELS chipset and i remember reading that it …
-
## Current Behavior
In case of incorrect readings of the compass after it was initialised the values are reset to 0. this might cause strange reactions to the drone.
## Steps to Reproduce
I d…
-
## Current Behavior
Currently INAV does not support Standard Remote ID (per FAA definition).
## Desired Behavior
INAV supporting an external board-powered device, communicating with FC over I…