-
Hey :wave:
I'm considering building something like this. Did you get it to work?
I'm thinking about using lekker switches with the same hall effect sensor you listed, any idea if that would work…
-
having a BOM compatible with JLC assembly service would be pretty helpfull for accessibility.
Might have a look later if I find the time.
-
Since the position of the holes for the switches is known, there should be possible to add a utility that places the footprints of the switches on a PCB according to the geometric layout of the keyboa…
-
This is not an issue but a reminder to everyone based on my experience.
CPLD is very sensitive to ESD! Mine got internal short after I plugged in/out cables a few times, while touching PCB leads. I…
-
Hello 👋
I am seeing odd behavior where some paths are missing after exporting from Affinity Designer, importing to Gingerbread and opening the resulting `.kicad_pcb` file in PCBNew. The paths in ques…
-
Power tool batteries may be common world wide?
Wall supplies too?
-
Would be nice to have that option to check the Li-Po voltage and an alert when the voltage is low.
I know that it needs a PCB modification but could be easy to make.
Chorus Laptimer has the option …
-
Hello,
I noticed this Call Attendant works well, but first ring still happens. This annoys me when I am woken up at 4am to a tele marketer single ring...lol. Sometimes two.
I know some folks bo…
-
-
#### Proposed Behaviour
Placer should be place instances to take advantage of dedicated routing resources
#### Current Behaviour
Placer only uses delay matrix to choose placement decisions
…