-
I am having issues using lm_sensors on XCP-ng. I always end up with `No sensors found!...`
I tried loading coretemp with modprobe and I encountered the coretemp error described in issue #249. I ins…
-
As soon as I boot the BTT SKR3 EZ board I get a TMC Connection Error reading ALL HIGH on all axis regardless of the number of drivers installed.
I cannot move any of the steppers while this error is …
-
Saying "the latest Raspbian" version doesn't help three years later.
I've got a Matrix Creator and a RPi 4 that I want to use as a 4-mic array with LEDs and I don't care what OS version I use, just…
-
Right now we can check whether electronic components (and our firmware drivers for them) are working by using the STM32Cube IDE's debugger. Once we get them to work, we will want an easier way to repe…
-
https://github.com/OSGeo/gdal/blob/fb8f5154c891c026c2bcfa5a398f4a993e00cc4d/gdal/frmts/pds/pdsdataset.cpp#L769
I think the only update required is to change the line above:
else if (EQUAL(valu…
-
I was able to get the current image from a Thorlabs uc480 camera using `instrumental`. My issue is when I try to adjust the parameters for `grab_image`. I can change `cx` and `left` to any value and …
-
I purchased ANAVI Infrared pHAT together with a temperature & humidity sensor (HTU21D), and attached it to a Pi 3 with a newly installed gateway version 0.10.0.
I was able to add the device in the ga…
-
Hello !
> \# lsusb
> Bus 001 Device 002: ID 1a86:7523 QinHeng Electronics CH340 serial converter
Tried blazer_ser and nutdrv_qx.
```
Network UPS Tools - UPS driver controller 2.8.0
0.0…
-
Bonjour, je possède une imprimante avec deux moteur pour l'axe Z, est t'il possible de configurer la carte pour alimenter les deux moteur?
merci
-
```
Hello.
Is there kernel support for USB HID devices?
I have a Temper1 USB temperature sensor/logger that is detected as an USB FTDI
device. Any chance to get it detected as an HID device?
Thank y…