-
I am using this image: c5soc_opencl_lxde_fpga_reconfigurable.img
But, the partition sizes are not very big, and the 2nd partition is the one with the Linux root FS on it, but there is a 3rd partiti…
-
Hello Rob,
I need a font with an extended ASCII-Set 256Bit. Because I use Letters like ä,ü,ö. Can you help me?
-
Hi! I have two ips displays of size 1.14 and 1.8 on the st7789 and st7735 controllers. I also use your libraries for controllers. For use in an optical system, it is necessary to flip/reverse the imag…
-
Hi, I have a TFT35 V2.0 with ESP01S attached. I am connected to my home WiFi. However, it is not working to transfer files to the SD card located in TFT35. Can anyone help? Thanks
-
How do we configure for more than 2 extruders? I have a 3 extruder setup, but I'm building a quad.
-
### Version
_PrusaSlicer 2.2.0-alpha4_
I'd like to suggest the addition of a few Placeholder variables, most (all?) of which are already exposed in the code/processor, but not addressable in the "…
-
Greetings. I'm new to all this and know very little about coding. I have a Tarantula Pro with Gen L v1.0 and added BL Touch. I successfully flashed the MB to get BL Touch working and auto-level fea…
-
Hello! I have acquired a tft28v4.0, as soon as I installed it and had no communication with my ramps 1.4, I changed ramps and arduino but the problem persists. I then bought a tft35 v1 to build my pri…
-
I am not able to get my machine to home. it throws an Unknown Command M420.
All I can find is about bed leveling.. I have that disabled as I don't have any bed leveling hardware
To add to this.. Th…
-
Hello, Is it possible to use a BTT SKR TFT35 or TFT70 type screen for choosing the Marlin or Graphic screen as on SKR Pro 1.2 or MKS L Gen L. I use the connector at the center of the Map with 5V, GND,…