-
X/Y Support Distance Priority
When printing with soluble support is is important to use 0 as your z support distance and x/y support distance to get good quality suppported surfaces. But, when pri…
-
Dear @rabbitstack,
I am a software developer who would like to actively contribute to the project.
I request the development of documentation that provides guidance on setting up a development en…
-
**Is your feature request related to a problem? Please describe.**
Bulging on seams, especially for thick layers.
Bulging on seams is reduced by tuning linear/pressure advance. However, these valu…
-
any chance we get a fork of the mmu3 firmware and i think 3.13 for the mk3s+ and mk4 support?
i was hoping to get rid of my mk3s+ and move it over to the mk4 i started looking at the firmware and s…
-
This value is more dependant on the extruder than the filament.
I should add a max_volumetric_speed_percentage into filament (so we can set 50% for abs, if it's harder to heat)
first discussed on …
-
**Is your feature request related to a problem? Please describe.**
Each filament spools requires different print settings on some specific parameters, therefore I need to save an entire Print Setting…
-
### Is there an existing issue for this feature request?
- [X] I have searched the existing issues
### Is your feature request related to a problem?
It's annoying to have the slicer selecting the w…
-
Cannot get any decent prints out of the Neptune 3 using Cura latest and Neptune 3 profiles. Stringing everywhere and terrible top layers. Have changed everyting in Cura (temp, speed etc) but nothing w…
-
**Describe the bug**
The support material is not printed for the first layer and as a result the support is printed in the air.
**To Reproduce**
Steps to reproduce the behavior:
1. Upload the mo…
-
I started catching freezes on the Adventurer 5M pro and on the Adventurer 5M. Adventurer 5M Klipper Mod v00.05-beta installed. Hangs in different places, different parts. Slicers PrusaSlicer 2.7.4, Or…