-
Dockerfile produces a container that can't be used in production.
-
Can you document the SPI setup?
I am not able to get the information into buffer and i don`t know how to setup the SPI.
EG - Mode-Duplex Master
Hardware NSS Output Signal?
Data Size: 8bit
CPO…
-
Can you explain which pins of the link cable to use:
Old "8bit" Plug:
---
| 6 4 2 |
_5__3__1_/ (at cable)
Pin | Name | Colour
1 | VDD35 | N/A
2 | SO | Red
3 |…
-
### The problem
While trying to configure a SPI bus on an ESP32S2 using the Arduino framework the build fails due to VSPI not being defined for this platform. For ESP32S2 and ESP32S3 FSPI needs to be…
-
Trying to build `v2.22.0` and running into:
```
[INFO] ------------------------------------------------------------------------
[INFO] Reactor Summary:
[INFO]
[INFO] MISO LIMS .................…
-
- Arduino board: Arduino Mega 2560
- Arduino IDE version 1.8.13
- List the steps to reproduce the problem below (if possible attach a sketch or
copy the sketch code in too): I am trying to conne…
-
I ran into an issue using the cluster to run miso, where the job id number is not properly parsed from the queue output. The error occurs at line 233 of ./misopy/cluster_utils.py (job_id = int(output[…
-
Yes, it is just a matter of calling
`SET_BIT(hi2s1.Instance->CFG2, SPI_CFG2_IOSWP);`
But, this is a matter of _exposure._
I wasted hours trying to figure out why RXDR was always zero. I triple ch…
-
```
What steps will reproduce the problem?
1. There have been requests for a tutorial on modifying pins_arduino.h to meet
the needs of custom-designed boards.
2. pins_arduino.h is not well documented…
-
Used both modes (emulated and not), but in both cases the screen (TFT35-B1 in a Biqu B1) always gets garbled after a little while.
```
#[display]
#lcd_type: st7920
#cs_pin: EXP1_4
#sclk_pin: E…