-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Transmitter firmware
### Current Behavior
v2.7 would l…
-
Testing with a device which is a VITA49 transmitter. Configure the device to transmit a VITA49 stream which conveys short IQ data.
Launch component SourceVITA49 in sandbox and configure it to recei…
-
```
As you know the CC128 supports 9 "appliance" sensors as well as the main
"house" sensor.
In our office we have two meters (don't ask), and CurrentCost advised us to
set it up as follows: one tran…
-
```
As you know the CC128 supports 9 "appliance" sensors as well as the main
"house" sensor.
In our office we have two meters (don't ask), and CurrentCost advised us to
set it up as follows: one tran…
-
Hi,
now, I turned receiver mode from managed to "monitor mode" to receive any packet while receiver do not even connect with transmitter(or any AP)
So now, I can receive various packets including pa…
-
hi all, what's up !
i have a P4P with crystalsky ( CS ) and 4HAWKS raptor XR antenna and i'm just looking for power , because i'm stuffed with loosing connection behind the vegetable garden hedge at …
-
I want to switch from Spektrum RC radios to FRSky radios, but my system requires the ability to send text messages from the remote system to the transmitter.
Spektrum has this capability - 9 lines of…
-
In 1.0 we will get antenna support to enhance the range. But to have interfering signals/transmitters (jammers) which highly suppress radio coms would open up a huge variety of missions and/or tasks.
-
Has anyone looks at what it would take to have a single binary for these 3 transmitters? The hall-effect sensor should be detectable, right? the v1 vs v2 may be harder...maybe looking at AUX5?
-
Any idea how to detect signal loss for implementing a failsafe over this protocol? It seems to spit out valid data even when my transmitter isn't turned on. Really appreciate your library BTW!
Than…