-
Hi,
at start, this is no issue, but question, or even function request.
I hve Wemos with oled and BMP280 inside office room. I see conditions, but co workers from end of room can't. I have custom …
-
### PROBLEM DESCRIPTION
After Upgrade to Version 10.0.0 the BMP Shields are not recogized on D1 Mini and WEMOS anymore
Upgrade was done over the air with: http://ota.tasmota.com/tasmota/releas…
Nesie updated
2 years ago
-
Hi Rob,
The AM2315-library works good, also when I use other I2C-pins, in my case SCL (19) and SDA (5).
Problems come up, with a BME280 and connected, in my case, to SCL 18 and SDA 23.
The AM23…
-
I use several sensors on the I2C bus. When polling every second, switching between them (call bmp.begin (0x76), bmp.begin (0x77)) after 45 minutes, a buffer overflow occurs and an error occurs, reboot…
-
## Current Behavior
Telemetry is lost enabling both GPS and Frsky F.Port over UART1 and UART2 and vice versa.
After disabling GPS under "Configuration" in INAV 2.5.1 / 2.6.1 and also 3.0.0, all valu…
-
I have some of these Purple Pill boards lying around:
https://stm32-base.org/boards/STM32F103C8T6-Purple-Pill.html
My Idea was to use them for your project, as they are small and have a proto area w…
-
I want to collect Data of my BMP280 and MPU9250 and save it on a micro SD card.
----------------------------- Remove above -----------------------------
### Hardware:
|ESP32 Dev Module
t…
-
### Describe the bug
On KAKUTEF7MINI(STM32F745) with gyro ICM20689 connected by SPI, the Gyro is stuck in callibration after ugrading to 4.3.0 nightly (42f2fc28e). It works perfectly on 4.2 (rollbac…
-
### Missing feature
I'd like to have an MPU-9250 Nine-Axis (Gyro + Accelerometer + Compass) sensor driver in NodeMCU Lua.
I have the [GY-91 sensor](https://www.narom.no/undervisningsressurser/the-…
-
## Current Behavior
with inav 3.0 and omnibusf4v3 firmware I cannot have HMC5883, but if I use 2.5.1 BMP280 and HMC5883 are working perfectly fine.
## Steps to Reproduce
1. install inav 3.…
krl91 updated
3 years ago