-
**Describe the bug**
Hello everyone,
I had something really strange yesterday.
I changed something in my settings and wanted to save the configuration to the SD card.
When I pressed the save bu…
-
Hi.
First of all, it's a great project, it's good to see that you can still get something out of such an old car. I did everything according to your project with minor hardware changes (I replaced th…
-
I am looking to sniff the CANBUS on a 2011 (1KD-FTV) Toyota, which uses SAE J2534 and [this](https://www.vxdiagshop.com/wholesale/vxdiag-vcx-nano-for-toyota-wifi-version.html) is one of the few dongle…
-
Hi Folks !
@christian: Thanks for the great Library !
My query is the same as issue #232., however I couldn't quite implement the solution.
I am using the library to actuate a CANBUS integrate…
-
What would be required to emulate a BYD H or HVL batteries? I'd like to be able to use this with a SMA SBS6.0-US-10 inverter and SBS-ABU-200-US-10 / BUUM3-US-10 whole-home transfer switch in Canada. …
-
I'm trying to install an sb2209 board using U2C wired into a pi. I'm trying to get the board into DFU mode but haven't had any success. All I see when running "lsusb" on my pi is:
- OpenMoko, Inc. …
-
I just had to uninstall and reinstall Klipper to fix a "dirty" issue. I installed Klipper with KIAUH then went through the install steps for BDSensor.
~/Bed_Distance_sensor/klipper/install_BDsenso…
-
Are there any plans for filtering CAN messages to be sent via MQTT directly on the device?
My use case is just to get the SOC of my BEV while it’s parked and charging in the driveway to use it with…
-
using the original version from uksa007 I have stable connection with the inverter but using this code it seems that the inverter loses connectivity quite frequently with the inverter, I get several a…
-
Hi, i m tryng to connect to my Seat but i recive some strange data, i have also triple checked the connectio and tried to swap tx and rx
I connect the cable to OBD port and RS232 to my laptop, afte…