-
I've been pulling my hair out trying to get the container version of this from dockerhub to work. I have it running just fine on bare metal though the container version would be better. I assume it…
-
**Description**
when i use arduinojson version 6, it's show xtensa-lx106-elf-g++: error: unrecognized command-line option '-cppflags'
exit status 1
Error compiling for board NodeMCU 0.9 (ESP-12 Mod…
-
### Problem description
I have a frustrating issue with this power plug. The first lot of 5 that I installed worked great and the power measurement sensors work accurately and consitently
So 2 w…
-
I'm using arduinoJson version 5.13.5
I want to send and receive data from mega to nodemcu esp8266
This is json data from mega to nodemcu using Serial2
`{"lux1":3440.719,"lux2":905.8619,"lux3":45…
-
Hi,
I have a ESP32 Heltec V2 Lora board. I use this ttn-esp32 firmware pack. I try to send a sensor data to the chirpstack Lorawan system, but I have a problem.
The Joining to the chirpstack sys…
-
Hello, I tried to connect our board to the ESP32 development board, and there was an error when loading the driver.
The following is the diagram of the hardware connection. We connected seven signa…
-
### Category
Hardware Compatibility, Other
### Hardware
Other
### Firmware Version
2.3.9.70712d85
### Description
Known issue but can't find an existing GH issue for this. Not sur…
-
### Preliminary Checks
- [X] This issue is not a duplicate. Before opening a new issue, please search existing issues.
- [X] This issue is not a question, feature request, or anything other than a bu…
-
How do I run this on an ESP32-S3?
-
with SB2240 after 20/30 minutes of printing I get the error 'tmc "extruder" reports error : GSTAT: 00000004 uv_cp=1 (undervoltage!)
(Ldo nema 14 pancake run_current: 0.65)
both motor and board are…