-
I am in the process of writing the support for my 3D printer (Renkforce RF1000) which has a special type of bed level probes based on a load cell to measure the force when the nozzle touches the build…
-
### The problem
repeiter-server integration not work.
The integration not work - Object sensor.ulti_bed_0 (and other) unavailable
### What version of Home Assistant Core has the issue?
core-2022.…
-
### The problem
The sensors for job_end and job_start in the repetier integration don't work anymore. Getting errors in the logs.
### What version of Home Assistant Core has the issue?
core-2021.…
-
I have RAMBO + reprap discount LCD and I am getting whiteboxes on my LCD display. I set and uncommented:
# define MOTHERBOARD 301
# define REPRAP_DISCOUNT_SMART_CONTROLLER
When I upload this version …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
When performing small diagonal moves (less than 3mm usually) and using G29 bilinear lev…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Marlin applies an incorrect Z offset after bed leveling, when using the simple "home" t…
-
Dear Marlin Community,
Im using the marlin firmware connected to repetier host, randomly and suddenly when printing the printer just stops printing, the repetier host gets stuck at a code (when sendi…
-
Firstly, I have been using Repetier firmware on my SeeMeCNC Rostock Max for over a year. Have it dialed in. I wanted to switch to Marlin for the delta calibration feature (and other things). I went th…
-
I run a few Gen 7 boards in my botfarm: 1.4.1 and 1.5s
I run Marlin on one Sanguinololu, but the Gen 7s thus far has been running Teacup and Repetier firmware
If I take one of the existing Gen 7s (i.…
ghost updated
2 years ago
-
I am using repetier host version 1.6.2 to test the UBL branch...
@Roxy-3D, I think the use of M as a parameter to G29 is not going to work smoothly with Repetier... and maybe other host software... s…