-
### Wiki Search Terms
Homing/homing cycle/seek_mm_per_min
### Controller Board
6-pack, v1p5
### Machine Description
The axis I am trying to run is using an external stepper motor driver. The moto…
-
Dear author, in your project "Legacy_stepper_motor_analyser" you used current sensors ACS70331EESATR-2P5B3 (x2 QFN-12 chip ). Can you make light redesign of the board and add place for SOIC-8 version …
-
```
When the X or Y Axis is moved, the stepper motor for Z is not 'enabled' thus
it tends to drift when the X and or Y axis move.
All is OK for the X and Y Axis, when either one moves, the other is l…
-
```
When the X or Y Axis is moved, the stepper motor for Z is not 'enabled' thus
it tends to drift when the X and or Y axis move.
All is OK for the X and Y Axis, when either one moves, the other is l…
-
```
What steps will reproduce the problem?
1. Call tone(13,31). You will see a very fast blinking on the LED.
2. Call tone(13,30). You will see a seemingly continuously lit LED (it actually
is a very…
-
```
What steps will reproduce the problem?
1. Call tone(13,31). You will see a very fast blinking on the LED.
2. Call tone(13,30). You will see a seemingly continuously lit LED (it actually
is a very…
-
```
What steps will reproduce the problem?
1. Call tone(13,31). You will see a very fast blinking on the LED.
2. Call tone(13,30). You will see a seemingly continuously lit LED (it actually
is a very…
-
Given that most 3D printer boards work with an ATmega processor.. could it be possible to use one of those boards as the base of this project with minor modifications to the code?
-
Hi I tried to rebuild firmware for S42B-V2.0 version. It works, however, built firmware has only 35kB while pre-build firmware 2.0 has 54kB. This is ok, but the OLED display refreshes very slowly when…
-
Thanks for the test unit @AlistairSymonds, I've spent the last couple of nights putting together some Python code that enables me to test out the device without needing a full INDI or ASCOM stack runn…