-
I want to use this card to control my fan. but I need more than one switch - one for speed (off, low, med, high) and a second column with oscillation (on, off)
-
Hi
I've managed to make it as a shield for Arduino, you can check it here:
https://oshwlab.com/epsi1on/ardbrood
It is still under development, just need a polygon pour to connect GND pins
Edit…
-
I am using ramses_cc to control my mechanical ventilation based on the Orcon MVS-15RH. My setup is using the following device to communicate CO2 readings to the ventilator, but at the same time it can…
-
I have 3 Haier Flexis AS25S2SF1FA-BH
and used your Haierv2.h file to ESPhome
Can change the auto / speed settings from the HASS
but when doing the same change in Homekit - it fails somewhy?
I can…
-
Copying from Discord to not forget :)
- [ ] inspired by echavet/MitsubishiCN105ESPHome#73 by @SixFive7, vane namings can use Unicode: AUTO", "↑↑", "↑", "—", "↓", "↓↓", "SWING" and "←←", "←", "|", …
-
**Is your feature request related to a problem? Please describe.**
I'd love to use this card to set the target temperature of a Thermostat
**Describe the solution you'd like**
Creating a big-slid…
-
Hello.
I have a problem integrating the Hisense AEH-W4E1 air conditioner. I installed and configured the Mosquitto Broker and HiSense Air Conditioners add-ons. Air conditioning can be controlled via…
-
Basically what the title says. The adhesion with some soluble support materials is really bad, and it would be nice to be able to print supports fast with the normal material, except for when it inter…
-
As the title says, running on the latest 1.8.3 firmware and following the instructions it doesn't seem to have any effect.
The on-device screen shows the fan speed at 50% (I've set it to 25% via th…
-
Has anyone managed to use this tool with Thinkpad P16 Gen 1?
I can't get past errors like these:
_[18.12.2023 14:24:42] failed to read FanSpeedHighByte 1 from EC
[18.12.2023 14:24:46] failed to r…