-
I have been using my DaVinci Duo for a few years with Repetier v0.91 without any problem (thanks a lot, by the way). I flashed it today with 0.92.10 and everything seems to work fine except for 2 issu…
TComp updated
6 years ago
-
Hi All,
Its been a while since we have discussed raster engraving. Currently using smoothieware we can raster engrave around 40mm/s without jittering. This speed is far too slow to make nice raste…
-
The order of operations are not being honoured when gcode is generated.
Step 1:
Add 3 documents.
Lets call them:
Doc1
Doc2
Doc3
Note, this is how they appear in the document list.
Step2:
…
ghost updated
7 years ago
-
#### What were you doing?
Upgrade to latest edge Firmware
Trying to print 20x20 calibration box (see attached gcode)
#### What did you expect to happen?
All layers aligned and extrusion perfec…
-
### Version
1.33.4-prusa3d
### Operating system type + version
macOS Sierra (Version 10.12.3)
### Behavior
* The "Export G-Code" button is disabled upon exporting G-Code one time.
* Reprodu…
-
Is anyone able to test the windows compatibility of this code?
I'm unable to, there aren't any windows machines in my house. Even my VMs are way out of date.
-
Reported by Walter K on G+
When choosing mm/min in Settings> Application, Should Jog>Control be changed to mm/min also?
Im not sure if we discussed this in the past and decided not to change t…
-
I used probing for milling a printed circuit.
When I start probing on a new 40 by 30 mm grid, the sensor moves way too far into the PCB for the first probe.
Luckily I use spring probing contacts, so…
-
Feature required to indicate if air-assist is installed and whether it needs to be activated during an operation.
Machine Settings ->
-Air-Assist Installed [Checkbox]
-- Air-Assist ON command [M…
ghost updated
7 years ago
-
Joseph
In the #198 issue you have mentioned that toolpath generation is planned to be integrated.
What is the game plan for implementing it?
I would recommend to use similar MDI windows based…