-
First of all, i love the project, and i promoted it here also to some other hams.
It works fine, and i will use it to manage my self made loop.
One observation, it seems the code is refreshing …
-
Hi I tried to rebuild firmware for S42B-V2.0 version. It works, however, built firmware has only 35kB while pre-build firmware 2.0 has 54kB. This is ok, but the OLED display refreshes very slowly when…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
I'm trying to find out why the lower priority serial link is distrupting the stepper motor pulses. As a result I have been examining exactly how the interrupts have been ported.
Digging through how …
-
I have steppers with a 0.9 degree step angle instead of the 1.8 degree step angle the S42B seems configured for. On the MisfitTech Nanosteppers, that these are based on, support for 0.9 degree steppe…
-
```
When the X or Y Axis is moved, the stepper motor for Z is not 'enabled' thus
it tends to drift when the X and or Y axis move.
All is OK for the X and Y Axis, when either one moves, the other is l…
-
Hi everyone, I am ending up in a very confusing situation. When I jog the machine while the spindle is turned off it works well but as soon as I kick in the spindle the machine starts to lose steps. F…
-
### Description
It would be good to have CHOPPER_09STEP_12V similar to CHOPPER_09STEP_24V.
I'm looked for some documentation on how to define properly CHOPPER_TIMINGs for 0.9 degree motors running…
kad updated
10 months ago
-
### Controller Board
Custom Esp32 board with TMC_2009 as standard_stepper (no uart)
![grbl32_pins](https://user-images.githubusercontent.com/3391893/179852304-e93dbc5e-1a29-4280-b959-cffae0232409.…