-
The following are issues when running Ubuntu on reTerminal.
1. reTerminal cannot reboot from Ubuntu. It gets stuck and the "SYS LED" stays turned ON
2. When reTerminal is powered off and powered…
-
Hi, I wonder if the firmware has any support for generic serial interfacing, like the STLINK V3 Bridge API enables?
Thanks!
https://www.st.com/en/development-tools/stlink-v3-bridge.html
https…
-
I want to transplant ucosii on spike,but how to print information without pk?
I refered to the transplantation of freeRTOS (https://github.com/illustris/FreeRTOS-RISCV).
It used 'tohost' to implemen…
-
Hi,
I have seen that you have cloned the OpenV2G repository and you have worked with this repository. I have seen that in the folder src/test there is a file named main_example.c that execute a cod…
-
Is there a way to debug boot-up problems?
I have a 033 display which bluntly refuses to boot your newest demo file. Also the old demo does not boot up anymore, I can switch between the stock firmwa…
-
2x Supervolt SX150P
- address: C4:08:7D:7F:B8:1C
type: supervolt
alias: Vorne1
- address: E6:F9:20:27:3C:31
type: supervolt
alias: Hinten2
Error:
ERROR [supervolt] (, BleakError('…
-
### The problem
Under the binary_sensor / rc_switch_raw we can define our own rcswitch protocol, but cannot use the code value, it's just a binary_sensor afterall.
Under remote_receiver / on_rc_…
-
Hi,
I am new to RPI and the PTP concept.
1) First I would like to ask what hardware do we require to generate a PPS pulse in the GPIO of the RPI and how to transfer it to data acquisition board (fo…
-
This would allow ESC's to be flashed without a need for a flight controller as suggested by @AlkaMotors
One could simply use a FTDI adapter or arduino or anything similar.
-
I believe some way to set baud rate for the serial traits is needed.
### Relevant problem
[Dynamixel](http://www.robotis.us/dynamixel/) servos comes with two different RS-485 protocols that have s…