-
### Creating an image request
#### Formal device information
- Device name | Orange Pi Zero 2W
- Official product URL | http://www.orangepi.org/html/hardWare/computerAndMicrocontrollers/service-a…
-
First, thank's for this great library!
I've managed to compile & run the sd_msc.ino example on PlatformIO / Lolin-S3 in a few minutes!
I wonder about the transfer speed, can only reach 200KB/s for…
-
Hi, at the moment this is really quite difficult to figure out. There were people on the forums having trouble too. I think it would be useful if there was a straightforward list of all the exposed pi…
-
This is a follow-on from #119 which never seems to have adequately resolved.
In addition to getting ~300uA on VDD_MCU when the event loop is idle, I always see ~1mA on VDD_USB. I believe this is …
-
I successfully installed Ubuntu 16.04 on my MBP 13,1 and everything went on smoothly. However, I found that if I closed the lid while Linux is running, and I opened it again, nothing would show up. Co…
-
As discussed on IRC (I may have misinterpreted things or got something wrong):
There needs to be a standard power/control interface for active probes (that lives separately from what carries the ac…
-
Really not sure what's causing this, the accelerometer works fine using standard Arduino and micropython code but through klipper this is all i get.
>
> `1:10 AM
> Invalid adxl345 id (got 72 vs …
-
I put together one of these and it works great under Linux/Wine. Thank you very much. I have an application that will require two of these tied to one computer. Is there a way to address each individu…
-
Using the [libicsneo-examples](https://github.com/intrepidcs/libicsneo-examples) project, re-opening a ValueCAN 4-2 device will fail.
```
$ ./libicsneocpp-example
Running libicsneo v0.1.0 HEAD @…
-
U-Boot SPL 2016.09-rc1 (Oct 01 2016 - 21:31:35)
init i2c
rand test 0 MB RW, err cnt = 0
DRAM: 512 MiB ~
CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2
sunxi_board_init ok!
Trying to boot from MMC1
mmc_dev=0
…