-
### Describe the bug
I have several quads, all of them equipped with M10 GPS. Both in 4.4 and 4.5 they can reach up to over 20 satellites, but HDOP is much much worse in 4.5 compared to 4.4 (with exa…
-
### Is there an existing CVA6 bug for this?
- [X] I have searched the existing bug issues
### Bug Description
I have error after executing the command (`work-ver/Variane_testharness rv64um-…
-
### Describe the bug
Building for MATEKH743 fails on macOS
```
betaflight % make configs
make: Circular configs ./obj/main/STM32H743/.efhash_818b631372f10ad09e29463180b1c7d7
%% startup_stm32h7…
-
Prototype, WIP version of this is here: https://github.com/adafruit/circuitpython/compare/master...tannewt:ninja
-
### Describe the bug
target: AOCODAF405V2
a) online firmware 4.5 ==> ESC telemetry RPM lost
b) online firmware 4.4.3 + SJET-AOCODAF405V2MPU6000.config ==> ESC telemetry RPM OK
### To Reproduce
…
-
### Is there an existing CVA6 bug for this?
- [X] I have searched the existing bug issues
### Bug Description
I want to generate a VCD file to view the waveform using GTKwave to see each signal. To…
-
### Describe the bug
Altitude is not display in the telemetry page on open tx when using a barometer only (work with a gps only)
### To Reproduce
A flight controller with a barometer, open tx, an…
-
Hi,
This seems cool - I'm just now realizing that the TM16xx protocol is both a read and a write one, so it seems that libraries will support both - or at least this does (due to the buttons thing)…
-
I have been attempting to use the "BitBang" shift register implementation in this library, but I was getting compiler errors on Arduino IDE 1.8.19.
To see whether the issue is in my code, my dev se…
-
Hi,
I am trying to use i2c_gpio (bitbanging) on nrf52840. I am unable to make it work yet! Did anyone test bitbanging i2c on nrf52840?
Following DT settings used.
```
gpio_i2c0: gpio_i2c { …