-
I tried to activate my inverters to read their data. Using pvdata I get an error which I think means it could not detect the device class.
```
mqtt: ssl disabled
mqtt: sma-em topic SMA-EM/status/30…
-
### PROBLEM DESCRIPTION
Have a battery operated ESP8266 with BME280 (and DS18b20) as a climate sensor with Tasmota.
Deepsleep is active. every 15 minutes the climate data of the BME280 is trans…
-
Wireshark trace:
```
User Datagram Protocol, Src Port: 10000, Dst Port: 10001
MQ Telemetry Transport Protocol for Sensor Networks
Message
Message Type: Register (0x0a)
Mess…
-
Log + valgrind output:
```
20210203 183156.972 CONNECT example 10 1F 00 04 4D 51 54 54 04 02 01 68 00 13 73 75 69 74 5F 75 70 64 61 74 65 5F 65 78 61 6D 70 6C 65
202…
-
I updated my WLED Lamp from 9.1 to 12.0 since the Lamp has stopped working.
WLED does not save the Configuration of the LED. I have carried out the "Hardware setup" under "LED & Hardware setup" and…
-
Hi, im running valetudo 0.3.1 and today robo was not accessable, so i restarted the robot and after that he was back with default AP. No ssh connection possible und no valetudo available at port 80.
…
xoxys updated
2 years ago
-
Hi,
Just want to give you notice that I am testing this with the X1 and it works just fine, it is just a bit more freaky to reach him.
```
./solax-test.py
InverterResponse(data={'Network Volt…
-
Hi there,
I've been using the MQTT-SN-GW with the Amazon MQTT Broker. I've noticed when the keep-alive time is exceeded that the SSL connection on the GW side may not be cleaned up properly. When t…
-
Can't get Unifi g3 instant detection working not sure if missing any setting or not will post my config if someone can point me in proper direction to try and get working. Running newest version of ca…
-
I'm not able to connect to a mjpeg camera stream through homekit and homebridge-camera-ui.
The preview in homebridge-ui > plugins > Homebridge Camera Ui > Settings > Camera > [camera name ] works w…