-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
APM must not apply any pulse width which is either higher or lower than the
present radio Transmitter.
It is observed that APM 2.26 AND 2.27alpha, have this proble. WHATEVER PULSE
WIDTH I CAN A…
-
```
APM must not apply any pulse width which is either higher or lower than the
present radio Transmitter.
It is observed that APM 2.26 AND 2.27alpha, have this proble. WHATEVER PULSE
WIDTH I CAN A…
-
```
- Copy relevant wiki pages into MP30 versions
- describe each board type
- all new features: OSD, PPM, Logo, ...
- Add a page describing all compatible extra hardware
- mag, spektrum, OSD, PP…
-
```
Feature that you'd like us to add or change you'd like us to make:
Recommend adding an offset feature in the CLI setup that allows tail draggers
to compensate for their angle rather than level th…
-
```
Feature that you'd like us to add or change you'd like us to make:
Recommend adding an offset feature in the CLI setup that allows tail draggers
to compensate for their angle rather than level th…
-
```
Feature that you'd like us to add or change you'd like us to make:
Recommend adding an offset feature in the CLI setup that allows tail draggers
to compensate for their angle rather than level th…
-
I am getting this error when trying to run this command I just set up the pi car and may have missed a step but can't seem to find out what it is
sudo python servo.py
Now servos will rotate to 90…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…