-
As of 3/22/2016, downloading and building the master branch on OS X fails.
I don’t claim to be an expert on makefiles, or github in general, but this looks like a patch file didn’t get merged correct…
-
OK, I don't even know if this is possible, either directly or indirectly. I have created an e-stop system that does two things. Kills the line power to my router, and resets my TinyG via the extra res…
-
Am trying to get a sense of what you have supported in the current 2.0 nightly builds for the TinyG G2 on a Due? I can connect, query settings, and do some config. But I am having trouble getting sett…
-
I was trying wirePrint in CURA 15.06.3 and it look nice, except it doesn't show correctly and then i try load gcode to Repetier-Host and it shows it good.
So I was wondering if there is any possibili…
-
There is a lot of confusion about E Stop judging by the things I have read on this site and other CNC sites, especially by people with little experience. I would like to weigh in with my opinion backe…
-
This is firmware I am using.
[fb] firmware build 440.20
[fv] firmware version 0.97
[hp] hardware platform 1.00
[hv] hardware version 8.00
[id] TinyG ID …
-
I imported image, converted to gcode and then ran the job. I noticed that laser scanning feed speed of the raster was inconsistent. As in the speed was changing a lot for a single X line scan. The gco…
-
I'm trying to build on an Rpi2 that's running the standard Debian Wheezy. Here's the error I'm getting. I can't figure it out. Any thoughts? I'd like to try to make this part of ChiliPeppr.
[ 3%] Bu…
-
I am running tg_pytest.py using the setup-no-machine-001.json file and with windows 7/python 3. It seems to be working now. Who should I contact to do so? Is there a forum where tg_pytest is being …
-
This is a complete dump of the terminal running a complete job.
Tested 57600, 115200, 230400 and 250000 ( this last one did not connect )
Always chokes on 300 aprox lines remaining in the queue
[Sm…