-
Hello,
I have a Excelvan HOP-E801 thermal printer.
how I can print bit image in the center?
I tried with setJustification but doesn't work with image.
-
Hi,
When I want to start printing with USB mode, nothing happend on the printer because cura doesn't send any temperature order for the extruder (0°C.
A temperature (205°C) is set for this material …
-
### Version
2.3.0 RC3, Linux
### Operating system type + version
Debian unstable/testing
### 3D printer brand / version + firmware version (if known)
Prusa Mini+, 4.2.1
Octoprint 1.5.2
##…
-
Hello mates,
I have been looking for a solution to this problem for two months.
When I try to print from USB or from BTT TFT24, the printer stops randomly. Motors on, heaters too: bad situation.…
-
With the klipper mod now available, I wonder if anyone thinks of maybe adding a RPI with a small screen to the printer?
While klipper still runs on the main board, you can run klipperscreen on the RP…
-
Hello,
I'm using the Ender5 pro along with BL touch sensor and had some fun using Octopi.
Since some time, a got some printing errors, the nozzle stop randomly and since some days ago it was refusi…
-
when using post processing script "filament change" after changing the filament the printer returns to the point that needs to continue and cura freezes and doesn't want to continue anything. After th…
-
```
I'm getting an import error after following the instructions for the Raspberry
Pi. It's a fresh install of the latest Raspbian image, and I'm using an Epson
TM-T20 over USB. I installed the de…
-
I was looking for a suitable driver for my TM-T88V and finally I found yours!
Just tested a bit and I saw that it always feeds the full Page, instead of stopping after content finishes, but it's no…
-
This report is regarding the most recent commit version of the firmware https://github.com/makerbase-mks/MKS-Robin-Nano-V3.X/commit/c51c92124170ccb5da17abbcd694a4a6115aded1
I'm using the MKS TS35 V…
ikkez updated
2 years ago