-
Hi,
i've found this on varius e-commerce sites
https://www.ebay.co.uk/itm/395142936473
it' s a pcb based on bk4802 and eeprom 24c08.
The eeprom calculator can be used for reprogramming th…
-
please take time to update the linux kernel to 6.6.y stable and work on updating the dtb/dtsi files to match the new format. also please join the emmc and sd dts in to 1 file as it should work as the …
ksbjr updated
3 months ago
-
Thanks for this very handy program. I want to use it to write to the EEPROM and I've configured my kernel with CONFIG_AT24=m. I've looked through the dts files and I'm uncertain about the changes I sh…
-
test code
`
program project1;
uses rpi_hal,pfio,sysutils;
var s:string;
begin
RPI_HW_Start([InitHaltOnError,InitGPIO,InitSPI,InitI2C]);
writeln('a');
I2C_string_write(RPI_I2C_busgen,$5…
90999 updated
4 years ago
-
How to place BK4802P in RX or TX mode? It does not have a dedicated TX-RX pin to commute like BK4802N.
Please help!
You use I2C to place it in RX or TX mode?
Do you have datasheet for BK4802P…
-
I am having trouble using "i2c_ioctl_write" and "i2c_ioctl_read" in the same script.
If I use only one of them, does not matter which one, it was great. It reads when I aske it to do so, and it wri…
-
Hi,
whit your software can i use a cep2102 based usb to ttl module for programming 24c02 eeprom?
if yes , how to connect pins ?
Thanks
Roberto
-
**Test case**
```systemverilog
// Input to the formatter, preferably a reduced test case.
module_a_top(
.signal_a (wire_signal_a),
.long_signal_b (wire_long_signal_b)
)
```
**Actua…
-
Hello,
In our system, I have an EEPROM device connected on i2c bus 0 at address 0x51.
after instantiating a new i2c device with the at24 driver (the default kernel one, unaltered).
```
echo 24c02 …
-
### Subject of the issue
Currently when you call `put()` with a struct, the entire struct is written to the memory whether or not anything changed. Could we have a method that checks it byte-by-byte …