-
Hello, Thanks a lot for this lib, I really appreciate the fact that every settings are so clear.
I was using TMCstepper lib before with accelstepper and I'am currently trying to migrate my code to yo…
-
I'm trying to use the TMC2130Stepper library along with the AccelStepper library in order to drive the stepper motor. The AccelStepper library requires making a function call `stepper.run()` for each …
csurf updated
4 years ago
-
Hi, I want to use Stallguard and a Library to run the stepper such as Accelstepper Library. I've combined Stallguard example and Accelstepper example. Stepper is running but output is:
> 0 0 55
0…
-
**Is your feature request related to a problem? Please describe.**
The Output Config Display tab for stepper motor configuration is unclear about what are the units of the three parameters required t…
-
Hi
I dont see AccelStepper.ino in TMC2208 example folder...
Any reason it will not work together, DIR pin mapping if used in UART mode?
Thanks
Daniel
-
First of all, thank you for creating this library and all the documentation in the `README.md`. This was extremely helpful in getting the driver working.
Right now, I am only able to control my ste…
-
Hello everyone. I would like to stop the stepper motor immediately after the limit switch has been triggered. If I call the `stop()` function, the stepper motor starts to decrease its speed depending …
-
I have ramps 1.4 with mega 2560 and i connect my steppers with A4988 Driver but its not working and my HC-06 not working too but my servo is working well here’s my code :
#include
#include
#inclu…
-
all the documentation and examples only point to being able to set the Microsteps if you have hardware serial. Unfortunately my setup does not allow for using another but an arduino nano that doesn't…
-
Hello
I am new to this and i need help to figure out the problem.
I am trying to build my slider and fount your program. Super excellent.
When i do :
Arduino IDE
Open the sketch, add the Bounce2…