-
Hi, sorry for this basic question but do I understand it right, that the values of all DMX channels need to be constantly transmitted in a certain frequency like 25 to 40Hz or FPS (refresh rate) and n…
-
I don't know if this is possible on an ESP32, but it would actually be really cool if there was an option to instead be controllable over Wifi via Artnet DMX, which would make the light compatible wit…
-
It will be awesome to see in the future a way to connect straight to ArtNet/DMX nodes.
Freestyler uses ArtNet To DMX which is a fantastic way to be able to use the Open ENTTEC DMX controller with …
-
Hi There, Just wanted to say thank you for all your hard work I have just tried to Run it But encountered some Errors
IDE: Arduino 2.2.1
board : ESP32 D1 Mini
Library: esp_dmx (3.1.0) -- ArtNet…
-
Hello there,
Upload is successful, but there is no output after the max485.
I've tried two different types of max485 boards and the result is the same.
For comparison, wled outputs dmx fine.
The…
-
-
Hello everyone
I have a question about the Generic Artnet Module.
The module works great and does exactly what it is supposed to do.
Is it somehow possible to display the DMX value of a specific ch…
-
I mean for example
ArtNet to DMX on an Enttec Open DMX or sACN to DMX
nt2ds updated
5 months ago
-
I would like to control the software via DMX Control. Are DMX or ArtNet supprted?
plin2 updated
7 months ago
-
Adding an Artnet Device as DMX receiver not working.
ArtNet Device stayed disconnected and reconnect didn't change that.
debug messages:
```
Player: listening on 37755
Debug: "https://raw.gi…
spezi updated
5 months ago