-
Will this work on the Atmega 328p on an Arduino Nano?
Thanks!
-
I spent a good amount of time troubleshooting my first attempt at a standalone programmer based on your wonderful examples. I had errors on my initial testing of the fixed filename sketch. As sugges…
-
Hi,
I love you library however it is missing some definitions in interrupt_pins.h for atmega 328p/168p and similar that can be choosen for example in miniCore and all have the same pinout and inter…
-
Hello!
I'm interested in porting this project to the Arduino OPTA(STM32H747XI)
Are there any suggestions in regards to replacing the Atmega based code of this project, for STM32?
Thanks!
-
First off, thank you for the awesome project.
I took a look at the kicad files but I'm confused about the atmega chip. When I exported the BOM, it stated that the atmega chip was the QFN package v…
-
Hi.
I've started working on some [code](https://github.com/luqasz/flash) for flashing / reading AVR atmega chips. As for now I got working reading flash from atmega32. atmega2560 seems to be a bi…
-
I'm attempting to use microzig, and I'm also very new to zig and the instructions in `README.adoc` assume that you have a lot of knowledge about zig and how microzig works.
I attempted to use the s…
-
Possible solutions:
- LiPo alarms (could maybe fit under top layer) - requires connector to split off
- Measurement and shutdown by external chip - low voltage disconnect (LVD)
- Measurement and shutd…
-
I have the synth all built and as mentioned in another issue I used the MXD1210CPA+ instead of the DS1210. I am able to flash the Atmega using an Arduino and set the fuses to E:FF, H:DF, L:E0, or E:…
-
Hi - I was looking at moving from atmega (w Arduino bootloader) to the Xmega CPU. I'm specifically interested in the ATXMEGA384C3. Does the Xmegaduino project support this chip? If not, is there a lot…