-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
-
Most of the ATmega/ATtiny symbols end their descriptions and use footprints starting with "QFN-xx" where they should perhaps be more specific, eg. "VQFN". The problem: Atmel could not seem to decide w…
-
### Describe the problem
The Arduino language features are not available after startup.
### To reproduce
- Have no attached boards,
- Start IDE2,
- Select `Arduino Uno` board (can be any),…
-
I am not so sure how difficult it is to add the support of mega0 AVR and Tiny0/1/2 AVR, similar to optiboot_x.
Stretch goal will be to add the support of AVR DA/DB/DD part, similar to optiboot_dx.
…
-
These warnings pop up when building AVR-LibC device libraries:
```
In file included from ../../../../../source/avr-libc/include/avr/io.h:759,
from ../../../../../source/avr-libc/…
-
The current "avrdude.conf" has the following description in three places: ".xmega", ".avr8x", and ".avrdx".
```
memory "data"
# SRAM, only used to supply the offset
offset …
-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
Hi,
your lib looks very promising. Unfortunately there are big problems with it. If I use it with Arduino then the controller always resets.
If I use it in Atmel Studio 7 it always compiles with…
-
Hi!
Would it be possible to use the jtag2updi chip not only work as a programmer, but also a transparent serial bridge between the USB to serial chip and the target? Preferable also automatic switchi…