-
Based on https://community.platformio.org/t/platformio-microchip-samr34-lora/10789/12.
The store https://electroniccats.com/store/ sells a few Atmel SAMD/E/R/C based development boards, for exampl…
-
**Describe your question or issue**
How do I set the TX power of my module?
If someone could point me to the relevant code.
**Environment**
This information is all important; it's hard to help…
-
Hi @tannewt
we are trying to port the SAMR34 to circuitpython, but I could not find the corresponding ASF4 in Atmel START for SAMR34
Can you help me know where to find it?
I see the ATMEL SM…
-
LoRaClass::random() reads the register once and returns the byte.
```c
byte LoRaClass::random() {
return readRegister(REG_RSSI_WIDEBAND);
}
```
This is wrong for two reasons:
1) LoRa ch…
-
I was looking at the part where you bridged the 16-pin pad so that the 6-pin RS232 pad gave you Rx/Tx (nice!). However, which USART are they connected to? USART0 or 1? I would suspect USART0 but would…
-
### Describe the problem
I have the following setup: https://github.com/arduino/arduino-ide/pull/1132#pullrequestreview-1031068976
When I start the application I see the following errors logged:…
-
ABP Mode, Class C
When I receive downlink, periodically this message repeat itself, then after a few minutes I receive the same downlink.
Any solution for this?
-
I am trying to get the BastWAN to work on LoRaWAN.
Region US915
Gateway RAK7258 (of course)
Server Chirpstack running on RPi 4
I started with the [BeeLAN library](https://github.com/BeelanMX/Bee…
-
The sender code has a compilation error:
```
Arduino: 1.8.16 (Mac OS X), Board: "BastWAN, Print & String use auto-promoted doubles only, config.h disabled, INTERNAL_USB_CALIBRATED_OSCILLATOR, 732.…
-
Sleep modes with the Arduino IDE
Examples
https://github.com/RAKWireless/RAK4260_Low_Power_demo