-
If there are any other ESPs or other such serial devices, onboarding will get stuck when trying to set WiFi, as it tries to set the WiFi on the wrong serial device endlessly. This isn't super common b…
-
## Bug Report
Hey there,
I've got a weird one. I am trying to use your csi driver on k0s and for some reason the mounting part does not work correctly. In the logs there is no mention of a fail…
-
I would like to access a ZFS zvol (block device) from the VM but can't figure it out for the life of me.
I saw references to block devices mounting in the documentation, and this comment that was pos…
-
Hi,
While following this doc, after installation of ceph-common packages, "ceph" command is not working as expected anymore. It is looking under /etc/ceph/ directory for conf and keyring files. So…
-
Hi
I would like to be able to control a LEGO Boost (or LEGO wedo/Spike) Hub with Micro:bit.
The hub connect via bluetooth Low Energy (BLE).
Makecode for Micro:bit allows to send/receive messages th…
-
tl;dr: On a fresh install of arch linux, i seem to have trouble creating a bcachefs system with more than 10 block devices behind it.
Here's the OS, bcachefs version and disks i am working with:
`…
-
### Hardware
T-Beam, T-Deck, DIY
### Connection Type
HTTP
### Local or Hosted
https://client.meshtastic.org
### Firmware Version
2.3.10.d19607b
### Description
When connecti…
-
Hi, I have a lot of wifi devices connected to the entire Mash Ausus network, my main RT-AX89X router has MAC address filtration for a maximum of 64 devices. Can you add the option of blocking the devi…
-
I am planning on Using an Arduino Pro Mini board for this project to attain different Light settings. I am not very sure if this will be an efficient approach in terms of power consumption. The batter…
-
Hi!
Just tried to flash a Manta M8P (V2.0) with Katapult / Klipper. It uses a STM32H723 controller.
Compiling and flashing Katapult was no big deal. And since I enabled the Status LED I can see…