-
Trying to build firmware with BLTouch option enabled, compilation stops with an error:
```
Compiling .pio\build\STM32F103RET6_ac_tri_f1\src\src\HAL\STM32\timers.cpp.o
Marlin\src\HAL\STM32\timers.cp…
-
Hi, i tried your extra in knowledge of not tested with bltouch - all seems to work well but bltouch won't release pin to touch surface of endstop. Would it be possible to support the bltouch?
-
I bought a bltouch, but it does not calibrate correctly, since there is a large gap from the nozzle to the table ! Where and how can this be changed?! Or do I need to flash it?
-
Bltouch does not work properly constantly gives different offset values Evan when done back to back , destroyed my print bed , ill stick to mainline klipper and use one firmware to proz z offset , th…
-
The BTT TFTs have a manu for manually testing the BlTouch probe. In there you can test the probe, deploy it, stow it..., but there is currently no support for the Biqu Microprobe. Since the Microprobe…
-
I replaced 10!!!! bltouches
I add new bltouch it works for several prints and stops working((((
Failed to verify BLTouch probe is raised; retrying.
!! BLTouch failed to raise probe
I have no h…
-
When compiling for CR4NT220801C10 version of the E3 Free-Run board with BLTouch support, BLTouch will not deploy.
Expected behavior would be that there was support for this board in the Marlin firm…
-
I have an intermittent endstop problem when starting printing. The first detection by the Z axis switch goes well and when it straightens it sinks into the bed. I updated to 1.5.4 seeing this bugfix (…
-
Having issue with Bltouch on newly installed EBB SB2209 RP2040 on manta m8p canbus. I'm able to manually pin up and pin down. but wont sense pin up doing touch mode. everything else works on the eb…
-
Goodnight,
I would like a photo showing how I connect the BLTouch cables to the board, and which Pin I put in the Marlin.