-
Hi
Which kilovault battery did you write kilovault_bms_ble for? I have a pair of 3600-HLX-v3 in the RV which has a bluetooth accessible bms and it doesn't appear to be for these....
I know Kilo…
-
### Describe the bug
**My Setup**
Victron Cerbo GX
Victron MPPT 250|100 Solar Charge Controller
Victron Multiplus-II 48/5000/70
Battery 1 - 280AH x18s LiFePo4, Daly 150A BMS, Parralel protection…
-
Hello, thanks for your great work, unfortunately I cannot get to to work with my unit SP04S034L4S200A.
I have included the log and the home assistant ESPHome configuration and hope to get some poi…
-
I want to enable wifi to transmit data to the dashboard. I am using commit: 3bd1fbab1f01fb142f51d2e3b791c772b77745f0.
What are the Kconfig options to enable wifi?
-
### Board
ESP32 DevKit v1 (ESP-WROOM-32)
### Device Description
ESP DevKit v1
### Hardware Configuration
No other hardware connected
### Version
v1.0.6
### IDE Name
Arduino IDE 1.8.15
### Op…
-
Hello, could you help with connecting ant bms 20s to stm32, the board has a connector for a display with pins "H" and "L", I guess that this can be a bus, you do not know the same protocol as that of …
-
hi, I think you connected via the display cable I would like to know if it was possible to connect to the serial interface of an ESP and / or what connections did you use to connect to the BMS?
-
I have been looking to find a BMS that is compatible with ardupilot for use on ROVER and have been struggling to find anything that you can actually buy without emailing the company just to get a pric…
-
**Setup:**
2x Seplos BMS (nicht mit BSC) verbunden mit je einem NEEY 4A Balancer
Beide sind im BSC (auf ESP32-wroom Dev Board) auf BT ID 0 und 1 eingetragen.
**Problem:**
Der Neey auf ID 0 …
-