-
### Describe the solution you'd like
while using both CUL868 and CC2531 they switch ttyACM0 and ttyACM1 sometimes when you boot your system.
within the CUxD you can:
TTYASSIGN=ttyACM1:NC
when the…
-
Considering that the supported tools are either not sold anymore or not supported, are there any plans to get cc2531 to work with more than just sniffing?
-
Too bad, it seems not to work with a CC2531, neither on Mac, Raspian nor Debian.
The Dongle is found:
[ 3.273108] usb 1-1.2: new full-speed USB device number 4 using dwc_otg
[ 3.425810] usb…
-
Hello,
I'm trying to use the zbjammer with the cc2531. I've flashed the cc2531 with the [Bumblebee version 2.1 revision 1](https://github.com/virtualabs/cc2531-killerbee-fw/releases/tag/release-2.1…
-
https://www.zigbee2mqtt.io/guide/adapters/flashing/flashing_the_cc2531.html
-
My issue looks pretty much as #24, however I have different target device.
My setup: CC2531 on the usb dongle, Arduino nano (tried different set of pins, I also checked they are good at both INPUT …
-
Hello,
I'm trying to use the zbjammer with the cc2531. I've flashed the cc2531 with the [Bumblebee version 2.1 revision 1](https://github.com/virtualabs/cc2531-killerbee-fw/releases/tag/release-2.1…
-
I already reflashed my CC2531 but I want to try your project. Is it possible to get default firmware to this device? Where can I download it?
r4t31 updated
4 years ago
-
Lumi round button WXKG01LM seems to pair ok but device is not registered:
```
homeassistant_1 | 2020-07-17 08:43:36 DEBUG (MainThread) [zigpy_cc.uart] Frame received:
homeassistant_1 | 2020-07…
-
Please consider adding option to flash CC2531 and CC2530 SOC with zigpy-znp if already been flashed with serial bootloader.
puddly has added instructions to zigpy-znp README.md with information on …
Hedda updated
2 years ago