-
We had a good discussion at IIW #39 about ways to enable offline presentation of non-mdoc credentials.
Options discussed:
- Extension of ISO 18013-5
- Pursue OID4VP over BLE
- Use CTAP/HYBRID as t…
-
Hi, 1st of all Great OS ! Thanks so much!
### Qubes OS release
4.2.1 (upgraded from 4.1.2) latest stable.
### Brief summary
just installed 4.1.2 stable a couple weeks ago, then upgrade…
-
Valid Solo - FIDO2 (USB only) USB-A with firmware 4.1.2 locked from SoloKeys on ArchLinux solo-pythob version 0.0.30.
"solo key reset" was done. No PIN.
"solo key credential info" and "solo key cred…
-
### Qubes OS release
R4.2 with latest testing update
### Brief summary
Software using libfido2 cannot detect CTAP proxy device.
### Steps to reproduce
1. Install Qubes CTAP proxy and `fido2-t…
zpc0 updated
9 months ago
-
From the CTAP [specs](https://fidoalliance.org/specs/fido-v2.0-ps-20190130/fido-client-to-authenticator-protocol-v2.0-ps-20190130.html#authenticatorGetInfo) you should be able to tell if an authentica…
-
*Contact*: Brianna Murdock / Jen Harmon
*Who*: Tuition Reimbursement Employee
*What*: Employee capability to provide Tuition Corrections
Employee ability to provide corrections:
- Correct Course…
-
Hi all.
I'm not sure if this is the right place to leave feedback on the [March 21st, 2023 draft of the CTAP spec](https://fidoalliance.org/specs/fido-v2.2-rd-20230321/fido-client-to-authenticator-…
-
[How to file a helpful issue](https://www.qubes-os.org/doc/issue-tracking/)
### Qubes OS release
R4.2
### Brief summary
Try to register or authenticate with Qubes CTAP, notice that when th…
-
ryan@STARFORGED:~/uru-card-fido2-authenticator$ platformio run --target upload
Processing esp32dev (platform: espressif32; board: esp32dev; framework: arduino)
--------------------------------------…
-
The test tool currently supports commands from version 2.0. `GetInfo` informs about supported versions.
For old commands, tests should differentiate between authenticator versions.
For new command…