-
I am getting the following in my ultrafeeder container log.
```
ultrafeeder | [2024-09-10 21:41:55.738][mlat-client][mlat.planespotters.net] usage: mlat-client [-h]
ultrafeeder | [2024-09-10 …
-
Got a much more powerful box to run adsb on, did a fresh OS install, installed the snap, copied the config over, and everything started perfectly..... (Running on an oDroid N2+ (Linux adsb-box 6.1.11-…
-
See forum post https://forum.virtualradarserver.co.uk/viewtopic.php?p=8719
-
```
$sudo systemctl status dump978-fa
● dump978-fa.service - dump978 ADS-B UAT receiver
Loaded: loaded (/lib/systemd/system/dump978-fa.service; enabled; vendor preset: enabled)
Active: a…
-
Could someone figure out the issue i'm facing here
```
root@rock-3a:~/stratux# make
make xdump978 xdump1090 xgen_gdl90 fancontrol
make[1]: Entering directory '/root/stratux'
cd dump978 && make …
-
Right now, it's not possible to compile it for bookworm. Any hints on how to move this forward? Thanks.
-
1. Stratux version: Latest Source, `7eeb32acf6fa31dc86ac94f95975e573f2619ae4`
2. Stratux config:
SDR: `single` ? IDK
GPS: `no`
AHRS: `no`
3. EFB app and version:
EFB platform: …
-
rtl_biast exists in container, but no options to enable bias tee at startup. Or I'm not found it...
-
Would probably be better to add all the various soapy drivers when soapy is installed in `soapyrtlsdr` and change containers compatible with soapy to use `soapyrtlsdr` as the baseimage in their Docker…
-
In areas with low UAT traffic, the data stream `dump978 (raw) -> uat2esnt -> readsb` will disconnect when there's no traffic after a while. This is causing a lot of connects / disconnects that are vi…