-
Found multiple electrical issues on BunnyBot2024 will discuss troubleshooting steps and symptoms will be found here.
-
Create a KiCad schematic with the necessary components.
Early BOM:
- MCU:
- RP2040 Pico W
- USB Port:
- USB C (P# TBD)
- FFC Connector:
- TBD
- BMC:
- TBD
- Battery:
- TBD
-
Reproduce:
CC2: F.ElectricLogic
CC2DB: F.ElectricLogic
CC2DB: F.Electrical
-
It would be useful for RF coil simulations (and other applications) if conductivity and permittivity were assigned to each compartment. These parameters vary with frequency so we might want to make b…
-
### The problem
I've noticed that I can only see whether electrical addition is being used (active/blocked/...), but not at which power level (in kW) it currently is operating.
I just confirmed wi…
-
I am looking for the energy usage values of heating, water and ventilation. If I use the
el_aufnahmeleistung_heiz_summe_kwh
sensor.el_aufnahmeleistung_ww_summe_kwh
they seem to be to low. If I…
-
### What client do you play on?
enGB
### Faction
Horde
### Content Phase:
Generic
### Current Behaviour
Electrical Storm does not rise player and other players even if they are stacked gets dmg…
-
#### Objective
To conduct a comprehensive evaluation of the existing electrical panel box to identify its current capabilities, limitations, and any necessary upgrades for the planned expansion to 42…
-
### What needs to change?
Currently, we have a synchronous version of the serial driver used by `electrical_protocol`. However, it would be great to have an asynchronous version of this driver. This …
-
### Client Version:
_No response_
### Issue Summary:
As per title
Wounds affected by this are:
- [ ] `/datum/wound/muscle/moderate`
- [ ] `/datum/wound/muscle/severe`
- [ ] `/datum/wound/elec…